JTAG BOX, eMMC and JTAG finder in one box, find and repair, forget about broken JTAG pads eMMC Programming Reading Programming and Recovery eMMC Samsung Firmware update, dead eMMC Flash Recovery eMMC programming with vendor firmware eMMC Android file explorer with wide functionality Full range of eMMC reconfiguration up to JEDEC 5.1 Specs SD cards support ( Read, Write, Erase, Lock, Unlock) Ability to run all Z3X software with box (PC/SC-CCID USB Reader onboard)
EASY-JTAG FIRMWARE SUPPORTS FOLLOWING FEATURES AT THE MOMENT:
- ARM7/ARM9/ARM11 PXA3xx, PXA270, Cortex-A8, OMAP850, Cortex-A9 Dual cores support;
- Multiple devices on JTAG chain are supported, thus TAP number selection is available;
- Any custom voltage level selection from range ~1.8V to 3.8V
- TCK/Adaptive clocking selection
- Halt core (NRST is not changed)
- Reset core (NRST is applied before halt)
- Direct Read and Write memory (by 8/16/32-bit mode or bulk transfers)
- Access to the control registers of ARM core (coprocessor 15)
- Program code breakpoints
- Run Halt Restart core
- 19 Pins Hardware Accselerated unique finder feature offered only by Easy- JTAG
- Updated CPU AT SAM3X8E vs LPC1768 in the old box.
Updated FPGA SPARTAN6 vs SPARTAN3 in the old box
Updated Power Logic – Full Digital PWM with ADC control.
MicroUSB Connector if additional power required.
VCC and VCCQ overload protection.
Updated host interface: USB 2.0 Device/Mini Host: 480 Mbps
Integrated ISP engine: Z3X High Power Pro Engine
ISP Support 1 and 4-bit connection now **
Added eMMC 8-bit high speed interface up to 48Mhz
Integrated NAND engine: NFC with 4 Kbyte RAM buffer and ECC
Integrated M-PHY interface.
Integrated SPI/I2C engine: up to 65 MHz for HSMCI and SPI clock lines
Integrated Self Test Core that exclude 90% faults in production.
Integrated CCID Card Reader for Z3X Software Use
